Directive 2004/22/EC of the European Parliament and of the council of 31 March 2004 on Measuring Instruments
The Ministry for Competitiveness and Communications (MCMP), through the Consumer and Industrial Goods Directorate of the Malta Standards Authority, is launching two Consultation Documents (ICD 01/2006 and ICD 01/2006a) on the implementation of the Measuring Instruments Directive in Malta. ICD 01/2006 seeks to determine the areas of application of the Directive and will be active from 2nd January 2006 till 27 January 2006. ICD 01/2006a launches the draft transposition of the directive based on the information gathered from the previous consultation. The latter shall be active during the period 13 February 2006 till 10 March 2006.
The Measuring Instrument Directive (2004/22/EC ) establishes the minimum criteria for the placing on the market and first putting to use (i.e. first installation) of ten categories of Measuring instruments (if they are subject to legal Metrological Controls). These criteria are sufficiently broad to allow for differences between the member states such as climate, different currencies, and different installation procedures. The directive is structured as a New Approach Directive with conformity assessment procedures (some of which ask for the intervention of a Notified Body), the ‘CE’ mark, the declaration of conformity and the ‘M’ mark. And the intent of the directive is the same as other New Approach Directives – the creation of a single market, this time for measuring instruments.
Metrology is the science of measurement. In legal metrology, activities related to the measurement of quantities are regulated by legislation for reasons determined by the State. These reasons are defined by the Measuring Instrument Directive as being public interest, public health, public safety, public order, protection of the environment, protection of consumers, levying of taxes, duties or fair trading. Hence a measuring instrument that falls with in any of the 10 categories mentioned in the Directive and that that is subject to metrological controls by the State for any one of the reasons just mentioned will fall with in the scope of the Directive.
The Measuring Instrument Directive applies to any of the following 10 categories of measuring instruments:
· Water meters;
· Gas metres;
· Active Electrical Energy meters;
· Heat meters;
· Continuous and Dynamic measurement of quantities of liquids other than water;
· Automatic weighing instruments;
· Taximeters;
· Material Measures (i.e. measures of length and volume);
· Dimensional measuring Instruments (i.e. measures of length, area and space
occupied by a solid);
· Exhaust Gas Analysers.
provided they are subject to Metrological controls in Malta or in another member state.
The Directive applies also to the first putting to use, implying that measuring instruments that fall within the scope of the Directive can no longer be put to use for the first time (i.e. installed) for the applications determined by the member state when the Directive enters into force. This holds even if they were used for such a purpose before the Directive comes into force. However the Directive does provide for a derogation of up to 10 years which serves as a transitory measure for such instruments. Measuring Instruments which comply to an existing specification which have been approved by the relevant competent authority can continue to be placed on the market and installed for a maximum period of 10 years provided reference of the existing specification is included in the transposition of the measuring instrument directive. After that period only measuring instruments that comply with the criteria of the Directive may be placed on the market and / or installed.
The Directive shall enter into force on 30 October 2006. Any derogation will cease to apply from 30 October 2016.
The first consultation document seeks to determine which applications of the instruments listed above shall be subject to metrological controls.
The draft text of the legal notice will be presented for comments during the second consultation document.
Any comments should reach the Consumer and Industrial Goods Directorate as follows:
- ICD 01/2006 by 27 January 2006.
- ICD 01/2006a by 10 March 2006.
Other Press Releases:
PR261950en
PRESS RELEASE BY THE MINISTRY FOR YOUTH, WELLBEING AND THE IMPLEMENTATION ...
PR261950